Jak zarobić wtyk modularny RJ50 10P10C na przewód – Zaciskarka HT-2092C? Poradnik Manual Tutorial

Jak zarobić wtyk modularny RJ50 10P10C na przewód – Zaciskarka HT-2092C? Poradnik Manual Tutorial


Hi! in this video I will show you how Insert the RJ50 10p10c modular plug on the cable here we have two sample plugs on cables from various barcode scanners this type of RJ50 modular plugs can be mounted as required there is no standard for the order of the wires in the plug here we have an example barcode scanner here we have the RJ50 socket and cable with plug sometimes this happens that the plug must be replaced (wear, damage) the RJ50 10P10C plug crimper is used for this which we can buy for around PLN 50 ($ 15) it is important to write all wire colors in a specific position depending on the connector here in connector 3, 8, 9 and 10 we have our wires at the beginning, using a crimp tool, we cut off the end of the wire Please note that the cables in the plug are long so we need to remove the insulation for a longer distance we can use the recess in the crimp tool to strip the outer insulation turn the cord several times and push it out that’s enough we remove the screen, foil and cords, if any and cut with scissors or cutters gently remove the foil if they are, strings too and cut off to leave only the wires needed we check the order as we noted we pre-arrange and cut so that the ends of the wires are even then insert it into our modular plug in order when everything is ok, press down to the outer insulation of the cable (outer sheath) went deep into the RJ45 plug as you can see here we verify that all the cables have reached the end of the plug! and crimper crimp the plug we verify everything is ok, we tighten it fully this can be done several times that the plug is perfectly seated on the cable! ok ready we verify again everything is OK! we can insert the plug into the socket and verify that everything works Thank you for your attention! I hope this guide will be useful to you. Hi! Like this movie. Subscribe to the channel. Write a comment. Share this video.

Danny Hutson

5 thoughts on “Jak zarobić wtyk modularny RJ50 10P10C na przewód – Zaciskarka HT-2092C? Poradnik Manual Tutorial

Leave a Reply

Your email address will not be published. Required fields are marked *