How To Replace Wireless LAN Module | OMEN by HP 873-0000, OMEN by HP Obelisk Desktop PC | HP

How To Replace Wireless LAN Module | OMEN by HP 873-0000, OMEN by HP Obelisk Desktop PC | HP


NOTE: Only certain models in this platform series support the configuration of the following components: glass side panel, dust cover, liquid cooling system, lighting control module, LED lighting bar. Before you begin: Remove the access panel. Removal CAUTION: Use care when disconnecting the wireless LAN antenna cables from the wireless LAN module. A damaged cable or connector can degrade desktop performance. Grasp the wireless LAN antenna connectors with a small pair of needle-nose pliers or tweezers And carefully detach the wireless LAN antenna cables from the wireless LAN module. Remove the P1 Phillips-head screw that secures the wireless LAN module to the motherboard and allow it to rise to the spring-tension position. Grasp the wireless LAN module by the edges and pull gently to remove it. Replacement Align the notch on the wireless LAN module with the key in the wireless LAN module slot on the motherboard. Keep the wireless LAN module at a 30-degree angle and insert it into its slot. Hold down the wireless LAN module and replace the P1 Philips-head screw to secure it to the motherboard. NOTE: The wireless LAN antenna connectors are labeled “1” and “2” And should be connected to the corresponding “1” and “2” labeled ports on the wireless LAN module. The front antenna is “1” and the rear antenna is “2”. Reconnect the wireless LAN antenna cables By gently pushing the connectors onto their ports on the wireless LAN module.

Danny Hutson

Leave a Reply

Your email address will not be published. Required fields are marked *