How to Replace the Display Panel Hinges (Touch) | HP ENVY 15-ae000, ah000 Notebook PC | HP

How to Replace the Display Panel Hinges (Touch) | HP ENVY 15-ae000, ah000 Notebook PC | HP


Note: The following video depicts a specific configuration of the notebook. The same removal and replacement procedures apply to all configurations of the notebook. Before you begin: Remove the optical drive (if installed), base enclosure, battery, wireless module, USB board, subwoofer, fan, RJ-45 door, system board, display panel assembly, hinge covers, and display panel. Removal Partially remove the wireless antenna cables from the routing channel on the display enclosure to gain access to the right display panel hinge. Remove the three 2.5 mm P1 Phillips broad-head screws that secure the right display panel hinge to the display enclosure. Remove the 2.5 mm P1 Phillips-head screw that secures the right display panel hinge to the display enclosure. Lift the right display panel hinge off of the alignment pins on the display enclosure and remove. The left display panel hinge is removed in the same manner. Replacement Place the right display panel hinge onto the alignment pins on the display enclosure. Replace the 2.5 mm P1 Phillips-head screw that secures the right display panel hinge to the display enclosure. Replace the three 2.5 mm P1 Phillips broad-head screws that secure the right display panel hinge to the display enclosure. Route the wireless antenna cables through the routing channel on the display enclosure. The left display panel hinge is replaced in the same manner.

Danny Hutson

Leave a Reply

Your email address will not be published. Required fields are marked *